This 3d printed case houses the already small [TP-Link TL-WR703N] but also makes room for a custom-made expansion board. The expansion board is created to make the device a lot more hacker friendly, and who doesn’t need a great case to hold it?
Mivel az útválasztó kártya már rendelkezik USB-portral (USB 3G modemekkel való használatra szánt) A kiegészítő cselekedetek USB-hubként. The stock USB connector is replaced by a pin header which mates with a DIL socket on the underside of the expansion board. through the use of an FTDI chip the expander uses three USB ports and a 2×10 pin header to break out the GPIO pins from the router’s processor. Csak két USB port látható a fenti képen. Ez azért van, mert a harmadik süllyesztett, és egy nyílás nem került hozzáadásra a házhoz. Ez furcsa volt, amíg el nem olvastunk, hogy a port jelzi, hogy egy alacsony profilú hüvelykujj-meghajtóval használható, lényegében belső tároló hozzáadása a készülékhez.
[Köszönöm a buzz]